I have not tested them yet, but they should run fine on Windows 10.

Regards,

Henry

Pega Academy

I upgraded my system OS to Windows 10 from windows 8.1 and started the VM ware. Could not access Pega. When I checked the ip address, it was very strange that no IP address was seen in the VM. I tried uninstalling and installing again, but it was of no use.

Tried the below approach and voila it worked!!!!

1. Right click on the VM and select "Network Adapter". Select the option "Bridged" and click on OK.
2. Power on the VM.
3. In prpc logic:, enter the value as  architect
4. In password, enter the value as password
5. In the architect@prpc:~s, enter sudo ifconfig eth0 192.168.40.129 netmask 255.255.255.0 and press enter.
6. Shutdown the VM and Power on again.
7. Repeat Step(s) 2 and 3.
8. Now type ifconfig and press enter.
9. The IP address is different. The IP address shown in my system is 192.168.1.101
10. In IE or Chrome, type the URL http://192.168.1.101:8080/prweb/PRServletand you should be able to view Pega 7.

Hope this is helpful, in case you find the similar issue.

Thanks,

Anuradha

Its really good to see pega image on windows 10.Steps mentioned worked well.

Also can use Oracle Virtual Box instead of VMware.