I am trying to figure out how to adjust localised values.
From the help files and PDN i understand the field value inspector tool can help to show which field value is used to translate in the context in which it is shown tho i can't seem to figure out how to access the tool.
I dont see the field value inspector, nor the inspector prefs at the developer toolbar.
Can anyone point me in the right direction?
Thanks in advance!
Message was edited by: Marissa Rogers - Added Category
I did a bit of peeking under the hood on prpc 6.2sp1. On that system, which does have the UI that Marissa cited, the following steps allow toggling field value inspection without using the UI cited by Marissa.
1) From developer portal, click the "run" icon on the activity form for the pzUpdateRulesInspectorOption activity.
2) On the popped up "run" box, give value "Field" (I gave it without the quotes when I tried it) for the mode parameter.
3) Click "run", and your field values will be toggled, which you can demonstrate by starting any flow and observe the field value icons on the "new" harness".
However, when I tried those steps on a Pega 7 system, I did not see the field value icons. /Eric
As an alternate solution, you can use UI inspector. Click on required field in section, from UI inspector click on "open property panel", which will show the cell properties. This is as good as Field rule inspector.