Posted: 12 Feb 2016 13:15 EST Last activity: 22 Feb 2016 12:32 EST
Loop on Perform Harness after update to Pega 7.1.9
We have just update from Pega 7.1.7 to Pega 7.1.9 and we have following issue:
Every time we perform an action under the Perform harness, new Perform harness is opened within the previous Perform harness, which ends up in a kind of Perform harnesses loop. (Please see screenshot and log attached)
We have a customized Perform harness but this it works fine in Pega 7.1.7 but not in Pega 7.1.9.
Does anyone face same issue? Which is the solution? Please advice, this is quite critical for our client.
It is fixed now. The issue was caused by the Action section included in the Harness.
In previous versions than P7 'action' section was included in the harness. After upgrade it was recommended to use pyActionArea instead Action section for the perform harness if you want to refer to old development built in previous versions of P7.
Client didn´t do a full compliance upgrade, they´ve only done a tolerance upgrade... so they were missing this small change.