Question

2
Replies
1284
Views
Close popover
Jaime Escobar Rueda (JaimeE47)
Escobar Rueda

Escobar Rueda
JaimeE47 Member since 2017 10 posts
Escobar Rueda
Posted: September 26, 2017
Last activity: November 6, 2018
Closed

OpenSpan Error While Executing Solution

Hi, community. Hope you were fine.

I am trying to run a solution and when I tried it, appears this error:

Also, I can add that I was modifying an automation and then appears "Entry Point Not Found", so I deleted it and added it again. In fact, that fixed the error but induced to this new error.

The solution appears to run normally but it is not ok to get this error.

Thanks in advance

**Moderation Team has archived post**

This post has been archived for educational purposes. Contents and links will no longer be updated. If you have the same/similar question, please write a new post.

Robotic Process Automation
Moderation Team has archived post,
Close popover This thread is closed to future replies. Content and links will no longer be updated. If you have the same/similar Question, please write a new Question.