Question

3
Replies
50
Views
Close popover
Lavanya B (Lavanya B)
Incessant Technologies

Incessant Technologies
IN
Lavanya B Member since 2015 7 posts
Incessant Technologies
Posted: September 8, 2017
Last activity: September 8, 2017
Closed

Param value is not moving to the sub flow after upgrade from Pega 6.2 to Pega 7.2.2

Hi All,

we have recently done with the upgrade from Pega 6.2 to Pega 7.2.2 after that we have observed that in most of the flows para values are not getting set I mean going blank.

Example: we have one flow in the connector we are calling DataTrasnform where we are setting Param.WBName value from a decision table here from the decision table the param value is set but when it comes to the sub flow via connector the value is going blank.

Note: Same code is working fine in Pega 6.2

can any one please help me

Thanks in Advance :)

Case Management System Administration Upgrades
Moderation Team has archived post,
Close popover This thread is closed to future replies. Content and links will no longer be updated. If you have the same/similar Question, please write a new Question.