Skip to main content
Contact a Moderator

Question

5
Replies
120
Views
 Nilotpal Chakraborty (NilotpalC1213)
Tata Consultancy Services Ltd.

Tata Consultancy Services Ltd.
IN
NilotpalC1213 Member since 2013 9 posts
Tata Consultancy Services Ltd.
Posted: February 13, 2017
Last activity: February 14, 2017
Posted: 13 Feb 2017 6:40 EST
Last activity: 14 Feb 2017 3:50 EST
Closed

Couldn't open properties panel of a repeating layout

Hi All,

I am facing this issue. I have created a repeating grid layout in a section now I need to edit the layout to add a sorting option in the operations tab of the layout. But I am not able to open the properties panel of the repeat grid. Also the gear icon is missing. The repeat grid has a page list as a source. PFB the design in the attached document.

Thanks in advance

User Experience
Moderation Team has archived post, This thread is closed to future replies. Content and links will no longer be updated. If you have the same/similar Question, please write a new Question.
Posted: 4 years ago
Posted: 13 Feb 2017 6:48 EST
Mounika Thatikonda (MounikaThatikonda)
PEGA
Senior Technical Solutions Engineer
Pegasystems Inc.
IN

Hello,


I have faced this behavior some time earlier. But after performing a browser refresh/ close and reopen the rule I was able to observe the wireframes.


Best Regards,

Mounika
Posted: 4 years ago
Posted: 13 Feb 2017 7:24 EST
Nilotpal Chakraborty (NilotpalC1213)
Tata Consultancy Services Ltd.

Tata Consultancy Services Ltd.
IN

Hi Mounika,


Thanks for the reply. I also tried out those things a lot of time. Even tried with another web browser but still was not able to open the properties of the layout :)


Do you suggest an SR for this because the section has got a lot other dependences and would take a considerable amount of time rebuilding it.


Thanks,


Nilotpal


 
Posted: 4 years ago
Posted: 13 Feb 2017 9:23 EST
Rowland Stilwell (rowlandstilwell_gcs)
PEGA
Director, Strategic GSA NA Engagements
Pegasystems Inc.
US

Please try to do a private edit of the rule and see if the new compilation resolves the issue. You could also try to do a private edit of pzAssemblePreprocess and save which should cause all sections to be recompiled this can had delays to processing so probably only appropriate in a development situation.

We'd prefer it if you saw us at our best.

Pega Collaboration Center has detected you are using a browser which may prevent you from experiencing the site as intended. To improve your experience, please update your browser.

Close Deprecation Notice